Woodworking press is used for planing plates and square materials to obtain accurate thickness. The planer axis of the single-sided woodworking press makes a rotary cutting movement, and the four rollers above and below the wood make the wood move into the feed movement, and pass through the cutter axis along the workbench. The double-sided woodworking planer is processed by two cutter shafts at the same time. According to the different arrangement of cutter shafts, the opposite or adjacent sides of the workpiece can be planed. The three-sided woodworking planer uses three cutter shafts to plane three surfaces of the workpiece at the same time. The four side wood planer uses 4-8 cutter shafts to polish four sides of the workpiece at the same time, which has high productivity and is suitable for mass production.
In the process of woodworking planer operation, if the rotation speed of cutter shaft suddenly slows down or abnormal noise is heard, the operator must immediately turn off the power supply. For troubleshooting of all I surfaces, remember not to use hand push when forcing, so that the cutter shaft and other parts will be worn.
In order to avoid leakage of electricity, the ground wire should be connected when the planer is running. The tools and sundries on the worktable should be cleaned and all the fixings should be checked to see if they are tightened. The parts that need to be lubricated need to be regularly added with some lubricating oil, and it is also necessary to carefully check whether the gearbox is in a flexible state. Only
when the state of all I surfaces is normal can it be started.